Checkline MESURgauge - Manual (Page 6)

MESURgauge Software
Data Bits
Select the number of data bits for the serial port, then click
the APPLY button below. The default setting is 8 data bits.
Parity
Select the parity setting of the serial port. The default set-
ting is “None” (no parity).
Stop Bits
Select the number of stop bits for the serial port. The de-
fault setting is 1 stop bit.
APPLY
Click this button to apply changes to the above settings.
2.2 Reading Request String
String to Write
Enter the command string to request a reading from the
instrument. The default string for Mark-10 gauges is “?
C” (no quotes). Select either or both of the CR and LF
check boxes to append the string as required. CR (default)
or CR-LF may be used for Mark-10 gauges. The default
string can be recalled by right-clicking in the box and select-
ing "Reinitialize to Default Value".
The ability to specify the request data command adds flexi-
bility in testing. For example, peak or average readings may
be read from the gauge. Additionally, it allows for the com-
patibility of MESURgauge with gauges not manufactured by
Mark-10.
String Read
This is the raw character string read from the gauge.
Display Codes
Display control character '\' codes (\r = carriage return, \n =
line feed, \s = space).
2.3 Gauge Name
Optionally enter a name to be associated with the gauge settings in
5