Checkline MESURgauge - Manual (Page 18)

MESURgauge Software
4.13 Pass/Fail Indicators
When the Use Limits check box in the Pass/Fail Limits frame in the
Test Setup tab is checked, the Pass/Fail indicators, shown below,
become visible. While acquiring data, the load values received are
compared to the upper and lower limits set in the Test Setup tab,
and the appropriate indicator illuminates. A fail condition is repre-
sented by a bright red indicator. A pass condition is represented by
a bright green indicator.
4.14 Pass/Fail Limit Lines
Horizontal lines corresponding to the pass/fail limits set are dis-
played on the graph in red.
4.15 Invert Load
See Section 3.5.
4.16 Invert Travel
This checkbox is not visible unless the travel port is enabled in the
Test Setup tab. For details see Section 3.7.
4.17 CLEAR
Sends a command to a Mark-10 gauge to clear peaks and start a
new average or external trigger test (if so enabled).
4.18 ZERO
Sends a command to a Mark-10 gauge to zero the display and per-
17