Record management, Manual record, Schedule record – COP-USA NVMS 1000 User Manual
Page 32: 6 record management, 1 manual record, 2 schedule record
29
NVMS-1000 User Manual
6 Record Management
NVMS-1000 supports manual record, schedule record, motion detection record and sensor alarm record. This
chapter will introduce the above four record types respectively.
6.1 Manual Record
Select a channel and click
button or right click to choose ―Open Manual Recording‖ to start recording.
Then click
button or right click to choose ―Close the Manual Recording‖
to stop recording.
Note
：
If a channel is recording, closing preview will give rise to stopping it
6.2 Schedule Record
In the control panel, click “Area & Camera Settings”
under Device to enter the interface.
Select a camera and click “Local Record of Device” as
shown on the right figure.
Enable
Schedule
Record
and
set
schedule
and
pre-recording time, record duration, etc.
Click “Local Record of System” as shown on the right
figure.
Under record of system , you can choose record stream and
set record schedule.
Note:
Please refer to section 3.2.2 for details.