COP-USA DVRC264-4CH_USB User Manual

Page 147

Advertising
background image

Digital Video Recorder User Manual

18

1. HOLD

TIME

It sets the record time after the alarm happened. There are two options to choose: 1 minute and 2 minutes. It also sets the
distant time of detecting the motion. If the HOLD TIME is 1 minute, the motion which is detected will only trigger the alarm
once in 1 minute.

2. CHANNEL
STEP1

Press "Up", "Down", "Left" and "Right" buttons to move the cursor.

STEP2

Press "Enter" key to switch the channel which you want to set.

3. DETECTION
"DETECTION" checked means to motion detection activated, unchecked means to motion detection disabled.

4. SENSITIVITY
It is the sensitivity of the motion detection.

The range is from ‘1’ to ‘8’. The bigger value is, the sensitivity is higher.

5. TO

REC

If select "TO REC" check box, DVR will record when there is motion event. If not, DVR will not record.

6. ALARM

OUT

There are two alarms out options to choose: ALARMOUT1 and BUZZER.

7. SCHEDULE
It is the schedule of the motion detection. The default schedule is everyday. Press "SETUP” button to set motion detection
schedule.

8. AREA
STEP1

Press "Up", "Down", "Left" and "Right" buttons to move the cursor.

STEP2

Press "SETUP" button to enter the Area Setup submenu.

It shows the setting of detection area (referred Fig3.11 Detection Area Setup). The fuchsia area means to be
unselected. The transparent live area means to be selected. There are four options of the Detection Area Setup
to choose:


ALL: All area will be detected.



CUSTOM: The part which you select will be detected.

Advertising
This manual is related to the following products: