Cub Cadet Z-Wing - Manual (Page 32)

Cub Cadet Commercial Z-Wing
28
12.28.On the early design, the rollers of the actuator
mounting bracket rode in a channel formed by
the bottom lip of the cable mounting bracket,
supporting the lift actuator.
12.29.The rollers on actuator mounting brackets made
since November of 2005 only contact the top
surface of the cable mounting bracket.
See Figure 12.29.
12.30.The lift actuator is supported by a separate
bracket. See Figure 12.30.
NOTE: Removal of the actuator and the actuator
mounting bracket are much easier on the mow-
ers produced after November of 2005.
12.31.Installation notes: See Figure 12.31.
• It is acceptable to grind a small flat on one side
of the head of the front clevis pin, perpendicular
to the bore for the hairpin clip, for ease of instal-
lation.
12.32.Assembly notes, continued:
• Reverse the disassembly process to install the
cables, brackets, and actuator.
• Lubricate the pivot points (clevis pins) with anti-
seize compound.
• Test to confirm correct operation and adjustment
of the hinge lift mechanism and associated
safety features before returning the mower to
service.
Figure 12.29
Rollers not enclosed in channel
Figure 12.30
Figure 12.31
Ground flat
Index mark