Cub Cadet 300 Series - Manual (Page 30)

AUGER SYSTEM
26
6. Carefully slip the auger control cable out of the speed con-
trol housing. See Figure 4.9.
7. On single-speed models, remove the nut and bolt that hold
the cable bracket to the handlebar. See Figure 4.10.
8. Slip the auger control cable out of the bracket.
9. Pull the cable upward from the opening created by remov-
ing the belt cover.
10. From above, the spring on the end of the cable can be
maneuvered to unhook it from the auger pulley brake arm
(the auger belt idler pulley is attached to the brake arm).
See Figure 4.11.
Figure 4.9
Auger control
cable
Figure 4.10
Auger control
cable
Inset:
cable
bracket
Figure 4.11
Cable-end spring
Eyelet in
brake arm