Delptronics Trigger Man - Manual (Page 10)

Trigger Man User Manual
V2
10 of 20
Configuration Mode
Configuration mode is used to set various options for the eight Output jacks and the Clock and Control
input jacks. The Step LEDs display the state of the configurable options.
Entering Configuration Mode
Enter Configuration mode by holding down the Mode button, then pressing the Start/Stop button, then
releasing both buttons. The mode indicator LED will blink, indicating that the module is in Configuration
mode. Press and release the Mode button to exit Configuration mode. The configuration is saved when
Configuration mode is exited, and is retained even when the power is off.
Changing the Configuration
The Step LEDs show the state of the configurable options. Turning the LEDs on and off changes the
options.
One Output LED will be illuminated to indicate the output currently being configured.
Turn Knob 1 to move a blinking cursor left and right across the Step LEDs.
Press Knob 1 to toggle the configuration option indicated by the cursor. That is, if the LED (and the
corresponding option) was on, pressing Knob 1 turns that option off, and if it was off, pressing Knob 1
turns it on.
Turn Knob 2 to change the output currently being configured. The corresponding Output LED will be
illuminated.
Press Knob 2 to toggle between configuring inputs or outputs. When configuring the inputs, all eight
Output LEDs will be illuminated.
The following pages describe each configuration option in detail. Once you are familiar with the options,
you can refer to the quick reference for a reminder of which LED corresponds to which option.
In the descriptions below, a filled circle  represents an illuminated LED, and an empty circle 
represents an LED that is off.