Doepfer MCV24 Midi CV/Gate/Sync Interface (device no longer available) - Manual (Page 13)

Maximum CV output from CV2 with Scale settings
Scale CV2 output Scale CV2 output
24 .............. 1v 36 .............. 1.5v
48 .............. 2v 60 .............. 2.5v
72 .............. 3v 84 .............. 3.5v
96 .............. 4v 108 ............ 4.5v
120 ............ 5v 132 ............ 5.5v
144 ............ 6v 156 ............ 6.5v
168 ............ 7v 180 ............ 7.5v
192 ............ 8v 204 ............ 8.5v
216 ............ 9v 228 ............ 9.5v
240 ............ 10v 252 ............ 10.5
255 ............ 10.6v
For use with pitch bender, each value of 4 will add one semi-tone to the range, so a typical Pitch
Bender depth setting of 2 semi-tones, would be a scale setting of 8 (actually the range is 2 per semi-tone, but
as the pitch wheel is centred and it is a +/- range, the range is considered to be a semi-tone in one direction)
SLEW (CV2)
This is where the Slew function is enabled or disabled for CV2. When on, the CV output voltage is
slewed, which means it’s rate of change is slightly lagged, this improves the limitation of the 7-bit MIDI
system. With controllers, aftertouch and pitch bender, a greater smoothness can be achieved using slew.
SLEW TIME
This is where the Slew time is set, which controls both CV1 and CV2. A setting of 0 (OFF), prevents
the CV from changing at all, a value of 1 is the quickest time, with 127 being the longest time.
Ed i t C V 2 : O u t p u t 0 1
Sl e w :On > >
Ed i t C V 2 : O u t p u t 0 1
Sl ewTim e :00 6