Crestron electronic Isys TPS-3100L - Manual (Page 42)

ISYS ® WALL MOUNT TOUCHPANELS
TPMC-15-QM-L
Isys i/O TM 15" Wall Mount Touchpanel Media Center w/QuickMedia™
Isys i/O TM Wall Mount Touchpanel Media Centers
www.crestron.com | 800.237.2041 | 201.767.3400
© 2007 Specifications subject to change without notice
USB: (2) USB Type A female, USB 1.1 ports for mouse, keyboard,
and storage devices
1
RS-232: (1) 6-pin RJ11 female, computer console port
Bidirectional RS-232 up to 115.2k baud
Hardware and software handshaking support
PC CARD A – B: (2) Type II PC Card slots for memory expansion,
project upload, and wireless NIC
1
ETHERNET: (1) 8-wire RJ45 with 2 LED indicators
10BaseT/100BaseTX Ethernet port
Green LED indicates network speed
Yellow LED indicates Ethernet activity
NET: (1) 4-pin 3.5mm detachable terminal block
Cresnet Slave Port (data only; 24V terminal not used)
Connects to Cresnet control network
PWR: (1) 4-pin DC power jack, 12.5V DC power input
(external power supply included)
PWR OUT: (1) 4-pin DC power jack
Connects to PWR jack using 9-inch 4-pin DC power patch cable
(included) when locating power supply remotely; passes 12.5V DC
power from PWR IN terminal blocks
PWR IN: (2) 2-pin detachable terminal blocks, paralleled
Used to extend power cabling up to 60 feet using 4 conductor,
14 AWG wire connected to a TPMC-L-IMC power interface module
(included) at remote power supply location
G: (1) 6-32 screw, chassis ground lug
D-A / A-D Conversion (QM): Burr Brown 24-bit, 48 kHz
Amplification: Biamplified, mono, 5 Watts for high-frequency,
5 Watts for low-frequency
Buttons
(4) Backlit “softkey” buttons, programmable
(1) Backlit hard reset button, reboots the touchpanel system
Connectors
QM IN 1: (1) 8-wire RJ45 female, QuickMedia input port
Signal Types: Dynamically configurable under system control as:
(1) RGB input with stereo program audio and (2) mic channels, or
(1) Auto-detecting component (YP
B
P
R
), S-Video (Y/C),
or composite video input with stereo program audio
and (2) mic channels;
RGB Format: RGBHV
RGB Input Resolution, Non-interlaced: 640 x 480 minimum to 1600
x 1200 maximum (60 Hz limit at 1600 x 1200);
Video/HDTV Formats: 480i (NTSC), 576i (PAL), 480p, 576p, 720p
and 1080i;
Horizontal Frequency: 15 to 100 kHz
Vertical Frequency: 50 to 85 Hz
Delay Skew Compensation: 0 – 22 nS
Connects to QM output port of a QM-TX or other QuickMedia device
via CresCAT-QM or CresCAT-IM cable;
Maximum Cable Length: 450 ft (aggregate distance from
QM origination)
QM IN 2: (1) 8-wire RJ45 female, QuickMedia input port
Signal Types: Dynamically configurable under system control as:
(1) RGB input with stereo program audio and (2) mic channels, or
(1) Auto-detecting component (YP
B
P
R
), S-Video (Y/C),
or composite video input with stereo program audio
and (2) mic channels;
RGB Format: RGBHV
RGB Input Resolution, Non-interlaced: 640 x 480 minimum to 1600
x 1200 maximum (60 Hz limit at 1600 x 1200);
Video/HDTV Formats: 480i (NTSC), 576i (PAL), 480p, 576p, 720p
and 1080i;
Horizontal Frequency: 15 to 100 kHz
Vertical Frequency: 50 to 85 Hz
Delay Skew Compensation: none
Connects to QM output port of a QM-TX or other QuickMedia device
via CresCAT-QM or CresCAT-IM cable;
Maximum Cable Length (Video/HDTV): 300 ft (aggregate distance
from QM origination);
Maximum Cable Length (RGB @ 60Hz): 216 ft for 640x480, 140 ft for
800x600, 84 ft for 1024x768, 70 ft for 1280x768, 30 ft for 1600x1200
(using CresCAT-QM or CresCAT-IM cable)
QM OUT 1: (1) 8-wire RJ45 female, QuickMedia output port
containing RGB output with stereo audio from internal PC and (2)
discrete channels from internal mic;
RGB Format: RGBHV
RGB Output Resolution, Non-interlaced: 1024 x 768 pixels @ 60 Hz
Connects to QM input port of any QuickMedia device via
CresCAT-QM or CresCAT-IM cable
HEADPHONES: (1) 3.5 mm TRS mini phone jack
Output Power: 105 mW per channel
Minimum Impedance: 8 ohms
w
a
ll mount touchpanels
100
TPMC-15-QM-L using a single QuickMedia Transmitter