Fire By Design VULCAN - Manual (Page 5)

5
Acceptable Media for Fire Features
24 volts
from
Transformer
Drain
Line
Gas
Line
Electrical
Conduit
Illustration of Properly Installed Vulcan Fire Module
1” above ring
Arrow
WARNING
Do not use any other material as filler/topping media inside fire features other than those listed below.
Using improper media inside a fire feature could result in damage to property or
injury to persons nearby due to media ‘popping’ or ‘exploding’ due to heat
Vulcan
Fire
Module
The illustration above shows the Vulcan Fire Module as it would look after installation is complete inside a small bowl.
1. First step is to apply pipe dope to the gas riser.
2. Next thread the Vulcan Fire Module onto the gas line ensuring it is tight to prevent gas leaks.
3. Then attach the two wires from the Vulcan Fire Module to the two wires coming from the 24 volt transformer.
4. Add Acceptable Fire Feature media as desired. (See next page for a list of Acceptable Media).
5. Installation Complete.
Installation
Note: Installation should be done by a qualified service technician that is locally licensed.