Fire By Design VULCAN - Manual (Page 7)

7
2. Turn fire feature on by turning on the electrical device used to power the fire feature.
Sequence of Operation during Ignition
- Power is applied
- Hot Surface Igniter (Glow Plug) becomes hot and 4 seconds later the Gas Valve opens
- Within 10 seconds of power application Flame should be visible (at night only)
Fire Feature Shutdown
1. Turn fire feature off by turning off the electrical device used to power the fire feature.
Maintenance
Prior to Each Use
1. Inspect for debris in Fire Feature – remove debris prior to use
Semi-Annually
1. Visually inspect the Burner for debris/insect infestation (spider webs)
Annually
1. Visually inspect Burner for excess corrosion due to heat and moisture.
2. Turn fire feature on to ensure proper operation.
WARNING
Maintenance should be done by a qualified service technician.
The appliance should be inspected before use and at least annually by a qualified service technician.
WARNING
Ensure gas and power are shut off and appliance is cool before servicing.
WARNING
Any guard or protective device removed for servicing must be replaced prior to operation.
WARNING
If fire feature fails to turn off completely (small flames still visible)
Turn off gas supply using the manual gas shutoff.