Freerider FR1 - Manual (Page 24)

23
Flash Description Meaning
1 Battery Low
The batteries are running low. Recharge the
batteries
2 Low Battery Fault
The batteries have run out of charge.
Recharge the batteries. Check the battery and
associated connections and wiring.
Note:
The low battery fault flash code,described above, is a requirement of various safety
standards.
The scooter will output a visible and audible low battery warning if the battery
voltage drops below 90% of its cut-off voltage.
The warning will be two short flashes, and will take priority over all other flash codes
in the system.
3 High Battery Fault
Battery voltage is too high. This may occur if
overcharged &/ or travelling down a long slope.
If travelling down a slope, reduce your speed
to mini mize the amount of regenerative
charging.
4
Current Limit Time-out or
Controller too hot
The motor has been exceeding its maximum
current rating for too long.
The scooter may have stalled. Turn the
controller off, leave for a few minutes and turn
back on again.
The motor may be faulty. Check the motor and
associated connections and wiring.
5 Park Brake Fault
Either a park brake release switch is active or
the park brake is faulty. Check the park brake
and associated connections and wiring. Ensure
any associated switches are in their correct
positions.
6 Drive Inhibit
Either a stop function is active or a charger
Inhitit or OONAPU condition has occurred.
Release the stop condition(seat raised etc.)
Disconnect the battery charger Ensure the
throttle is in neutral when turning the controller
on. The throttle may require re-calibration.
7 Speed pot Fault
The throttle, speed limit pot, or their associated
wiring may be faulty. Check the throttle and
speed pot and associated connections and
wiring.
8 Motor Voltage Fault
The motor or its associated wiring is faulty.
Check the motor and associated connections
and wiring.
9 Other error
The controller may have an internal fault.
Check the motor and associated connections
and wiring.
3.Status Fault Codes: