FRITSCH PULVERISETTE 1, Model I classic line - Manual (Page 31)

Page 29
14. Slide the cable clamp (H) onto the funnel cable.
15. Then screw on the cable clamp (H) at this position with the cylinder head
screw M6x12 (G).
6.3 Crushing and comminuting to the fineness of a disk mill
Coarse material can be comminuted to the fineness of the disk mill in one pass by
combining it with the disk mill „pulverisette 13“.
The fragmentation is performed with this combination in a single pass from 95 mm
(or 65 mm) input size to an average grain size (d
50
) of 0.1 mm.
Install the jaw crusher over the disk mill in a mounting rack (order no. 43.5100.00).
The preground material from the jaw breaker slides down a special chute directly
into the hopper of the disk mill.