Hardy HI 6300 Series - Manual (Page 69)

Instrument Configuration 61
•
•
•
•
•
•
The available parameters on the device are:
• Stability test
• Weight and Voltage
See the Chapter 9 for further information on Diagnostics.
Display Parameter Menu
The following sets of parameters are only active from the display panel when the display
panel is attached to the instrument. They are not enabled on the Web Page.
• Backlight
• Power Saving
• Set Background
• Set Foreground
• Split Screen (HI 6310 only)
o Display Mode
o Discover (Command)
o Num Display
o Display Order
Backlight Parameter
The Backlight parameter sets the display panel brightness level in 16 equal steps shown as
a progress bar on the instrument.
On the HI 6300 series instrument display, select the display menu and use the UP or
DOWN button to select the Backlight submenu. The current Backlight level will be
displayed, press the ENTER button if the value needs to be modified, and use the LEFT or
RIGHT buttons to set the required backlight level. Press the ENTER button to set and save
the backlight value.
Power Saving Parameters
To conserve power the display can be automatically dimmed towards a blank screen. While
the weight value is not in motion for the programmed Wait Time, the text is dimmed in 2
steps towards the blank level for the display. If the weight value is in motion, or the ENTER
button is pressed on the display, the value returns immediately to the preset background and
foreground levels.
Auto Enable Parameter
The Auto Enable parameter is used to turn ON or OFF the power saving mode.