Hardy Enviro Bench Scales - Manual (Page 14)

Section 6: Serial I/O
12/09 9 0596-0315-01 Rev B
4.5. PROGRAMMING STEPS
Setup Menu
1. Press and hold the Program/Enter key or press S1 on the main PCB to display SEtuP.
2. Press the Program/Enter key to enter setup mode.
3. Press Zero to set the desired Programming Menu.
Default selections are shown underlined.
Programming time format: This will determine whether the clock is displayed and printed in 24 hour
(military) or 12 hour (AM/PM) format. The display will indicate either 12 hour or 24 hour. Press
Over/Under/Next or tare to change the selection. Press Program/Enter to enter the selection.
Set-ti: Programming the Time: Time is set as HH.MM.SS and must be entered in military format. The
display will indicate set-ti followed by the current time with the 10s digit of the hour flashing. Press units to
increase the digit or the 1 button to decrease the digit. Press Over/Under/Next to move the flashing digit right
or press tare to move the flashing digit left. When the time is correct, press Program/Enter to accept the time
and go to the next step.
Set-da: Programming the date: Date is set as MM.DD.YY format. The display will indicate set-da followed
by the current date with the 10s digit of the month flashing. Press units to increase the digit or the 1 button to
decrease the digit. Press Over/Under/Next to move the flashing digit right or press tare to move the flashing
digit left. When the date is correct, press Program/Enter to accept the date and go to the next step.
Id: Scale ID: This step sets the scale ID from 1-32. The display will indicate id xx where xx is the current ID
setting. Press Over/Under/Next or units to increase the setting, or press tare to decrease the setting. When
the correct ID is displayed, press Program/Enter to enter the value. The default Id is 01.
Port 1: Programming Port 1: The display will indicate port 1, then output, then the current setting. Press
over/under/next, units or tare to scroll through the available choices. Press Program/Enter to enter the
correct selection. Available selections are:
OFF Function is not active.
PoLL Computer demand mode.
PoLLid Computer demand mode with ID.
Contin Continuous output.
button Transmit when print is pressed.
Auto Transmit occurs when Autoprint threshold is met or exceeded.
diS Continuous output using remote display format.
Baud: Programming Port 1 baud rate: The display will indicate baud then the current setting. Press
Over/Under/Next or units to scroll up, or tare to scroll down through the available choices. Press
Program/Enter to enter the selection. Available selections are:
300 600 1200 2400 4800
9600 19200 38400 57600 115200
Dbit: Programming Port 1 data bits: The display will indicate dbit x where x is either 7 or 8. Press
Over/Under/Next , units , or tare to select proper value. Press Program/Enter to enter proper selection.