JMC Installing Online Software - Manual (Page 23)

JMC Online Software Page 23 of 81 Last update on 7/17/08
Figure 12: Editing a JMC web server configuration file.
b. For the line that contains #JMC_ONLINE_IP 127.0.0.1, remove the initial
# symbol and edit the IP address appropriately. The IP address should be
the address of the server that will have the JMC Online Software on it.
This server would typically be the same server that would contain the JMC
data and transcript folders, but other configurations are possible.
c. For the line that contains #JMC_ONLINE_PORT 3000, remove the initial
# symbol and edit the port number appropriately. If you plan on using
more than one CGI (EL, MS, & HS), each would need a unique port
number for each building for each year. For example, for the 2006-07
school year, EL could use port 3000, MS could use port 3001, and HS
could use port 3002. For the 2007-08 school year, EL could use port
3100, MS could use port 3101, and HS could use port 3102. Please refer
to Table 1 for the recommended sequence of port numbers for a specific
school year.
Year
Port Number
Sequence
2006-2007 3000, 3001, 3002…
2007-2008 3100, 3101, 3102…
2008-2009 3200, 3201, 3202…
2009-2010 3300, 3301, 3302…
2010-2011 3400, 3401, 3402…
Table 1: Recommended Port Numbers by School Year
d. Save the changes to this file. Remember to do this for the JMC.conf file
for each building.
Remove the
# from the
beginning of
this line and
edit the IP
address –
should be IP
address of
server where
JMC Online
software will
be installed
Remove the
# from the
beginning of
this line and
edit the port
number