Kimber Ultra Carry - Manual (Page 29)

29
Please follow the simple procedures below for
disassembly of the slide.
1. Visually inspect chamber to make sure
firearm is unloaded.
2. Follow standard disassembly procedures found
in this Owners Manual, with the exception
that special observation should be given that
the grip safety is not to be engaged when
removing the slide.
If the Grip Safety is depressed while attempting to
remove the slide, the push rod for the firing pin
stop will be activated. Activating the Grip Safety
will not allow the slide to be removed, if forced,
damage could occur to the firearm, which will not
be covered under Warranty.
DISASSEMBLY (FIELD STRIPPING)
This product should be cleaned after every use and
when exposed to dirt, sand, etc. When not in use,
clean at least twice per year.
1. With the pistol unloaded and the magazine
removed, retract and lock back the slide.
Locate the exposed small hole in the recoil
spring guide rod. Insert the take down tool in
the hole in the guide rod and carefully
release the slide stop. (See diagram)