Kimber Ultra Carry - Manual (Page 33)

33
ASSEMBLY
To reassemble, follow steps in reverse order. The
most difficult procedure is often the alignment of
the barrel link with the slide latch hole in the frame.
The alignment can be seen through the hole and
link can be aligned by moving the slide very
carefully back and forth until it drops into place Do
not try aligning the link and the semi-circular
disassembly notch and top of the slide stop at the
same time. Align the link first, insert the slide stop
shaft and then rotate the slide stop upward until it
aligns with the disassembly notch. Then push the
slide stop inward until it is properly seated.
1. Re-assemble by inserting the barrel then the
compressed spring assembly, (take down tool
first) into the front of slide.
2. Replace the slide and slide stop.
3. Rack the slide, by hand, letting the take down
tool drop out.
DISASSEMBLY NOTCH
(PIN)
SLIDE STOP