Kimber Solo - Manual (Page 40)

LUBRICATION
1. Use a premium firearm lubricant such as
Shooters Choice FP-10 or similar quality oil
(grease is not recommended). If oil contains
Teflon, be sure to shake well before using as
Teflon settles when left overnight.
2. Lubricate the following internal parts:
a. Slide and frame rails - One drop per side
b. Trigger Spring, Trigger Bar
and Sear Spring – one drop each
c. Barrel hood - one drop, spread on hood.
d. Slide stop pin - one drop, spread with
finger.
e. Recoil Unit: Between sleeve
and Rod – One drop.
f. On Recoil Sleeve – One drop
g. Outside of Barrel - One drop, spread with
fingertip.
h. Magazine Catch Button: one small drop
each side then exercise the button.
3. Reassemble as previously described.
NOTE: DO NOT PLACE
LUBRICANT INTO THE
FIRING PIN CHANNEL
(FIGURE 24).
40
X XXX
24