Kistler-Morse KM SVS2000 - Manual (Page 69)

65
www.kistlermorse.com
97-1129-01 Rev. D
SeTTIng up TracKIng
Follow this procedure to set up zero and material tracking:
1. If the SVS2000 is in Run Mode, press the ‘8’ Key, ‘3’ Key, and Enter Key to access the menu tree. The
display shows:
83 mAT FLOW THrS
2. Press the enter key to access this menu. The display looks like this:
> 18.0 lbs/m
(Units are consistent with Disp Units.)
3. Use the numeric or Arrow Keys to input a value. Press the Enter Key to save the value in memory. The
display acknowledges the entry and returns to:
83 mAT FLOW THrS
4. Press the up Arrow key to proceed to the next menu. The display shows:
82
5. Press the enter key to access the Sample Intrvl menu. The display shows:
> 10 sec
6. Use the numeric or Arrow Keys to input a value. Press the Enter Key to save the value in memory. The
display acknowledges the entry and returns to:
82
7. Press the up Arrow key to proceed to the next menu. The display shows:
88 ZerO CLP WIn
8. Press the enter key to access the Zero Trak Win menu. The display looks like this:
> 0 lbs
(Units are consistent with Disp Units.)
9. Use the numeric or Arrow Keys to input a value for Zero Trak Win. Press the Enter Key to save the value
in memory. The display acknowledges the entry and returns to:
83 ZerO CLP WIn
10. Press the Down Arrow key to 82 menu. The display shows:
82 DrIFT LImIT
11. Press the enter key to access the Drift Limit menu. The display looks like this:
> 140.0 lbs
(Units are consistent with Disp Units.)
12. Use the numeric or Arrow Keys to input a value. Press the Enter Key to save the value in memory. The
display acknowledges the entry and returns to:
82 DrIFT LImIT
13. Press the Down Arrow key to go to the 81 menu. The display shows:
81 mAT TrACk enAB
14. Press the enter key to access the mat Trak enab menu. The display looks like this:
TrACkIng By *OFF