Kofax Communication Server 9.1 - Manual (Page 92)

Environment Guide Version 3.00.04
92 © Copyright Kofax, Inc. All information is subject to change without notice.
Test 3: Secondary Server Standalone
– Primary Server comes back and boots from
Secondary ’s disk
This is the same situation as in Test 3 with the difference that the Primary Server cannot access its KCS
File Structure and has to boot from the Secondary Servers disk.
Action completed Time needed Total time
Primary Server power on 0:00 0:00
BIOS initialized 0:38 0:38
OS booted 0:52 1:30
Secondary detected Primary (and restarted) 0:15 1:45
Handshake complete 0:10 1:55
Booted from Secondary Disk 0:27 2:12
1
st
Fax Channel available 0:35 2:47
Full system available 0:35 3:22
Unavailable time 1:52.
8.1.3 Operation of Line Server Model 305
Front View of L INE S ERVER Model 305
1 6 x 2 c h a r a c t e r
L C - D i s p l a y
M o d e
S e t
L A N 2 L A N 1
P R I 1 P R I 2 B R I 1 B R I 2
On the front side of L INE S ERVER Model 305 there are connectors to BRI/PRI and LAN lines. Each plug has
2 LEDs that indicate Status and Activity as shown in the tables below. Please note that there are slight
differences between the LEDs of LS1V1 and those of LS1V2. General Status information (version, IP
address and heartbeat) is shown on a LCD. 2 buttons are provided to reset the L
INE S ERVER Model 305 and
to setup IP-Addresses.
Find a description of Front side controls also in the Line Server Model 305 Manual!
Description of LAN LEDs on LS1V1
The LS1V1 is the old Line Server Model 305. It contains a TC16 main board and up to four TC22 modules
with a DSP processing power.
Connection Left LED Right LED Example
no LAN signal detected off off
10 Mbps LAN connection steadily green flickering green to indicate activity
on LAN
100 Mbps LAN connection steadily green flickering yellow to indicate activity
on LAN
Description of LAN LEDs on LS1V2
The LS1V2 is the new generation of the Line Server Model 305. It contains a TC18 main board that already
includes the DSP processing power.