Kofax Transformation Modules 3.5 - Manual (Page 19)

Kofax Transformation Modules Installation Guide 11
Use the following instructions to create and run a silent installation file.
➤ To create a silent installation file for Kofax Transformation Modules
1. Select Start | Run and enter cmd to open a window.
2. Within the window, change to the folder that contains the Kofax Transfor-
mation Modules setup file. If the setup is located on a network drive, re-
member to map the network drive first.
3. Run the setup from the command line by entering the following command:
setup /r /f1"FullNameResponseFile.iss" [/f2"FullNameLogFile"] [/
Verbose"FullNameDetailedLogFile"]
Parameters
/r
Runs the setup and records it.
/f1"FullNameResponseFile.iss"
Specify the full path and name for the recording file, for example “C:
\SilentInstall\ServerSetup.iss”. Note that the extension for the file is
“iss.”
/f2"FullNameLogFile"
Use this optional parameter to create a log file. Specify the
full path and name for the log file, for example “C:\SilentIn-
stall\ServerSetup.log”. As the extension for the file you may use
either .log or .txt.
/Verbose"FullNameDetailedLogFile"
If you want a detailed log file, use this parameter instead of the
/f2
parameter.
Specify the full path and name for the log file, for example “C:
\SilentInstallAXP\ServerSetupDetailed.log”. As the extension for the
file you may use either .log or .txt.
Important Make sure that the directory to which you save the recording or
log files is accessible with read/write permissions, otherwise the files can-
not be created.