Press the memory/recall button, To erase all measured values stored in memory, I recalling stored measurement values – Panasonic EW-BU04W User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I Recalling Stored Measurement Values
Measurements can be recalled after measurement is completed or after the power has been
switched off.
1. Press the Memory/Recall button.
• After the memory number has been displayed for
2 seconds, the latest record will be displayed.
2. To display previous data, press the Memory/Recall
button again.
C
OFF/ON
START
ST^
3. Press the Off/On Start button to cancel
measurement value recall.
• The power will switch off automatically after
approximately 30 seconds.
To erase all measured values stored in memory:
(1) Press the Memory/Recall button to recall stored measurement values.
(2) Press the Memory/Recall button again and hold It pressed until the measurement
values disappear (approximately 3 seconds or more).
*lt Is not possible to erase single measurement values.
(3) The
M
mark and - -will be shown when all data is deleted.