Panasonic EW-BU04W - Manual (Page 16)

I About Each Mark
To perform a correct measurement, this unit provides a movement detection function and an
irreguiar puise warning function. When the marks appear, the correct measurement might not
have been obtained. If any mark appears, it is recommended to repeat the measurement.
Stay cairn and reiax for four to five minutes, before performing a new measurement.
* The
and mark wiii be recorded together with the measurement vaiue.
Movement detection function
Pulse
gj* 89” fill
TTTTTT
Pulse
u g
The movement detection function is to indicate, with
s^yz-. extra pressure on the cuff caused by
movements of the arm during the measurement.
When movement is detected and the measurement is
completed, the mark is displayed after flashing for
approx. 6 seconds.
If the movements exceed acceptable levels, no
reliable measurement can be performed and the error
message “U 12” will be displayed.
irreguiar puise warning function |
■
If the pulse rate varies by more than ±25 % from the
average while a measurement is being taken, lahbh
will be displayed when the measurement is completed.
The mark is displayed after flashing for approx. 6
seconds.
If the LABBB mark is displayed an irregular pulse rate is detected, which is not
necessarily caused by arrhythmia.
• Don’t try to interpret readings or attempt to treat any condition yourself. Always follow
the guidance of a health professional.
• However if this mark continues to display, consult your physician.
Advice:
In general, blood pressure measurements are lower for the second measurement
because you are less nervous and are more tranquil. For people who easily get tense,
measuring twice each time is very effective. It is recommended to store all values when
performing two measurements or more. When taking two measurements, always stay
quiet for 4 to 5 minutes after the first measurement before taking the second
measurement.