Panasonic NI-W950A - Manual (Page 9)

Note: Do not overfill the Water Tank. The steam will release through the vents when the iron
is positioned vertically.
HOW TO USE AS A STEAM 1ROIS5
1. Fill the iron as described in “ HOW TO FILL WATER ”.
2. Position the iron vertically and be sure the Temperature Selector is set to “ 0 ".
3. Plug the AC cord into the household mains socket.
4. Set the Temperature Selector to the steam zone (“ o ” to “ è? The Thermostat Operating
Indicator Light goes on.
If the temperature of Soleplate is high, the light does not go on.
“ ” zone: Low steam, for thin or delicate fabrics requiring a small amount of steam.
“
&
” zone: High steam, for fabrics requiring a lot of steam, (i.e. thick materials, items with
stubborn wrinkles).
5. Preheat the iron until the Indicator Light goes out, usually it takes about 1 minute.
The light will go on and off while ironing to indicate the temperature chosen by the Temperature
Selector is being maintained.
6. Hold the iron horizontally and set the Steam/Dry Selector to the steam position.
7. Whenever the iron is positioned vertically, the steaming action will stop.
Note: The Anti-Drip System will activate when the temperature of the Soleplate’s surface
drops. At the same time, the steam will stop. It is not a sign of malfunction when you
hear a clicking sound. The Thermostat Operating Indicator Light will be on. Wait until
the Thermostat Operating Indicator Light goes out.
. i::w "G «SE ■■ o."
s
-=
a
.
vi
" " .
e a t
-
e
The “Jet of Steam” feature provides extra steam which goes deep into the garment and is helpful
for removing stubborn wrinkles. The “Jet of Steam" feature operates properly only in the “ MAX ”
position of the Temperature Selector when steam or dry ironing (If used at lower setting, water
spotting will occur because the iron is not hot enough to change water to steam). If you have
not used the “ Jet of Steam ’’ feature for a long time, it is necessary to clean the inside of the
iron before using this feature on any clothes to be ironed. Simply test the “Jet of Steam" feature
several times away from the ironing board and clothes to be ironed. This will prevent brown spotting
or water spotting on the clothes.
1. Fill the iron as described in “ HOW TO FILL WATER".
2. Position the iron vertically and be sure the Temperature Selector is set to “ 0".
3. Plug the mains lead into the household mains socket.
4. Set the Temperature Selector to the “ MAX ” position.
5. Preheat the iron until the Thermostat Operating Indicator Light goes out, usually it takes about
1 minute.
6. Simply pump the “ Jet of Steam Button ” when steam is desired. Pump the “Jet of Steam
Button” several times at the beginning of each ironing session.
7. Press the “ Jet of Steam Button ” in intervals of at least 5 seconds between use to prevent
water spotting. Use a press cloth if necessary.
© I
HOW TO USE THE “ VERTSCAL STEAM ” FEATURE
To get better results when using vertical steam, hang the garment on a clothes hanger. Curtains
and drapes may also be steamed once they are hung. Hold the iron away from your body, close
to but not touching the fabric. Pull the fabric tightly with your free hand and pump the Vertical Steam
Button (Jet of Steam Button) at 5 seconds intervals as you press the iron over the wrinkled fa'bric.