AAF International DynaPure - Manual (Page 3)

3
5.3 Final Filter
The optional final filter is shipped separately to avoid shipping
damage. Install as follows:
1. Slip the final filter housing over the DynaPure outlet until the top
edge of the outlet is approximately even with the break in the
sides of the final filter housing.
2. Fasten with the self-drilling screws provided.
3. Seal the joint on the inside with the caulk provided.
4. Set the final filter cartridge in the top of the housing and
latch in place.
1
Final Filter
Cartridge
Outlet
DynaPure
Outlet
Figure 3. Final Filter Installation
Section A-A
3
2
DynaPure
Self Drill
Screw
Caulk
1
2
4
Final Filter
Housing
A
A