AERCO ECS Retrofit User Manual
Page 36
36
ITEM
QTY
PART DESCRIPTION
PART NUMBER
1
1
LINKAGE ASSEMBLY
24038-1 (1” TO 3” VALVES)
2 1
SCALE
59028-1 (1” VALVE)
59028-1.25 (1.25” VALVE)
59028-1.5 (1.5” VALVE)
59028-2 (2” VALVE)
59028-2.5 (2.5” VALVE)
59028-3 ( 3” VALVE)
59028-4 (4” VALVE)
3
2
8-32 HEX NUT
123322
4
2
3/8-16 X 5/8 LONG CAP SCREW
54014
5 1
GASKET
81046
Figure 4-3. Linkage Installation Details
4.1.2 Actuator Installation
Remove the Actuator Assembly (69009) from the Retrofit Kit and install as follows:
1. Depress and hold the Clutch Button (Figure 4-4) and rotate the pointer to approximately 80° on
the dial. Release the Clutch Button when properly positioned.
CAUTION
DO NOT DEPRESS THE CLUTCH BUTTON WITH POWER APPLIED TO
THE ACTUATOR
2. Slide the Actuator onto the Linkage Assembly Shaft (Figures 4-2 & 4-4). Ensure that the pin on
the Linkage Assembly is inserted in the center slot on the bottom of the Actuator (Figure 4-4).