ALTANA BYK-mac ROBOTIC Manual - Manual (Page 13)

12
3.2 Mounting of standards
The instrument is supplied with a white calibration
standard and a cyan and effect checking reference.
The standards are to be installed perpendicularly in
order to avoid getting dirty. Please make sure that
the four round rubber-bonded metal attachments are
in place on the backside. These attachments
provide the necessary elasticity when putting the
instrument on the standards.
The drilling scheme for the attachment of the
standards, as well as the alignement between
instrument and standard are explained on a drawing
which is supplied with the instrument.
3.3 Manual measurement
In order to perform a manual measurement e.g. on a
master panel, the manual measurement adapter
(optional) has to be installed on the instrument to
guarantee the correct measurement plane. Put the
panel on the adapter and press it slightly until the
panel is aligned flat.
Mounting and Manual Measurements
White standard
Cyan and effect
reference