AltiGen MAXCS 7.0 Update 1 Softswitch Deployment Guide - Manual (Page 6)

Page 6 of 14 MAXCS 7.0 Update 1 All-Software Solution Deployment Guide
• Process voice mail
• Call recording
Provide conferencing resources
• Barge-in/silent monitor/coaching
• Station conference and MeetMe conference
For a full explanation of HMCP and the roles it plays in the MAXCS All Software Solution, review the training
presentation “What is HMCP?” in the AltiGen Communications Knowledge Base.
Preparation
We recommend that you take these steps before you begin the installation process:
• Have the System key and software license keys available, and make sure you have your login
information for the Partner portal.
• Make sure that the server is a member of the Active Directory Domain.
Quick Start
The first time you deploy this Softswitch version of MaxCS, we advise you to go step-by-step through this
entire guide, starting with the section Installation on the next page.
For subsequent installations, however, here is a brief summary.
1. Install and run HMCP Tool
On the CD, run
Setup (right-click and choose Run as Admin) in the ..\Server Application \ HMCP
Certification Tool folder. Restart. In Windows, choose Start > All Programs > AltiGen HMCP
Certification Tool. Make sure All In One is selected, click Start. Write down maximum values. Exit.
2. Install MAXCS
On the root directory of the CD, run
Setup. Choose Softswitch System Installation. Choose
Softswitch and HMCP. Accept defaults. Click Register Later. Accept defaults, click Install. Install
KEYLOK. Enter the country, area code, and extension length. Restart.
3. Add System Key
In MaxAdmin:
License > License Information. Registration. Check Use Soft System Key. Enter
the system key (UPPERCASE). Click Add License. Click Online Register.
4. Register License
In the browser, click
Proceed to Online Registration. Login. Add more licenses if needed. Click
Continue. Accept Assurance & Warranty Agreement. Enter contact info, click Continue. Download.
5. Load License
In MaxAdmin License Info page, click
Load, select the EXCTL file. Close. Restart switching (Start >
MaxCommunication Server > Utilities).
6. Assign HMCP Resources
In MaxAdmin: double-click
HMCP under Boards. Click Board Configuration. Enter values; do not
exceed maximums from step 1. Click Apply. Restart.