American Access Systems Advantage DKSII - Raintight Unit - 24-1000D - Manual (Page 5)

Page 5 American Access Systems / Security Brands, Inc.
STEP 2-SYSTEM CONNECTIONS HOOKUP STEPS
(A). Make all your prox slave connections BEFORE you apply power to the master unit. To connect power to your
new desk unit plug the wall tranformer into an outlet and insert the other end in the back of the unit.
(B). Connect the device(s) to be controlled to the appropriate terminal(s)(Relay A or B) on the Communications and
Relays Board.
(C). Double check your connections. When you are sure you have the unit hooked up correctly, apply power to the
unit. If this is the first time power up, the unit will perform some self diagnostics and setup the memory. The unit will
flash the LED’s several times while it is performing the first time setup. If everything goes O.K., you will hear a GOOD
BEEP from the unit. If the unit does not perform as above, quickly turn off power to the unit and contact American
Access Systems.
NOTE: THE UNIT WILL ONLY PERFORM THE SELF DIAGNOSTICS AND MEMORY SETUP THE FIRST TIME IT IS POWERED UP.
FROM THERE ON OUT THE UNIT WILL SOUND A GOOD BEEP IMMEDIATELY AFTER POWER IS APPLIED.
STEP 2 -SYSTEM CONNECTIONS
HOOKUP STEPS
CONTROL RELAYS
COMMUNICATIONS & RELAYS
PRINTER POWER HOOKUP
ACCESS CONTROL UNIT
(ACU)