AXEON Fluid-O-Tech Repair Rebuild - Manual (Page 5)

08/09 Ed., Rev. B Page 5of 16
# 9) Metal Tube
Tube to press the bearing onto the shaft. This can be any
squared off metal tube with an ID of .440” and an OD greater than
m 1.25”. Note that this tube must contact the inner and outer ring of
the bearing, otherwise the bearing could be damaged upon install.
# 10) Blocks or supports
Blocks or supports to hold the pump when pressing pieces in or out.
# 11) Repair kit
Repair kit for the Fluid-O-Tech rotary vane
pump you plan to repair.