AXEON Fluid-O-Tech Repair Rebuild User Manual
Page 7
Advertising
08/09 Ed., Rev. B
Page 7of 16
6) Once the bearing is out, support the pump again on its rim with the bearing end facing up,
making sure nothing is obstructing components from being pushed out of the body. Now use
the metal rod (material #5) to press out the washer, counterface, and any remaining pieces.
Be sure that the rod presses only on the washer, and not on the small retaining ring or lip.
The pump body should now be empty, with only the small retaining ring and ball bearing o-
ring left inside. These are normally reused.
Advertising