Blinds Chalet Floral Pattern Roman Shades - Manual (Page 5)

Custom
Roman
Shade
5
The brackets must be level – use a Spirit Level if necessary to assure
proper alignment.
Pre-drill the mounting holes using a 5/64” drill bit, then screw the
brackets in place.
Place the head rail on top of the brackets – center the shade over
the window opening – then mark the location of each mounting hole
on the head rail. Pierce the fabric at the hole locations using the tip
of a screw, then pre-drill the mounting holes using a 5/64” drill bit.
Attach the shade to the brackets using the 3/4” screws provided.
For Inside Mounting:
Mounting holes are pre-drilled in the Head Rail. Screw the 1-1/4”
screws into the head rail until the tips of the screws extend very
slightly beyond the top of the head rail. Align the front of the
shade with the front edge of the window opening (or position as
desired), making sure that the shade is centered in the window
opening – then push up on the head rail so that the screw heads
leave tiny impressions in the top of the window frame.
Now, use the impressions as a guide and pre-drill the mounting
holes using a 5/64” drill bit – then screw the shade in place.
Step 4. Install the Tension Device – FOR CONTINUOUS LOOP
CORD CONTROL SHADES ONLY!
The tension device reduces the hazards of
strangulation and entanglement of young
children or pets by limiting access to the
control cord. Anchor the Tension Device
that is attached to the shade’s control
cord, to the window frame or wall, so
that young children cannot pull the cord
around their necks.
Lower the shade, and then position the
Tension Device on the window frame or
the wall so that the Tension Device and
control cord do not interfere with raising
and lowering the shade.
The Tension Device should be installed
without stretching or pulling down on the
control cord. Stretching the control cord will cause excessive
wear. Do not twist or cross the control cord. Mark the screw
hole locations with a pencil, then pre-drill the screw holes using a
3/32” drill bit.
For hollow dry wall installation, use wall anchors (not included).