Blinds Chalet Silverscreen Roller Shades - 4% - Manual (Page 2)

Shades WITH Headrail
Step 3. ATTACHING FASCIA PANEL (IF ORDERED)
Attach the fascia by first hooking the
top lip of the fascia panel onto the
bracket as shown.
Swing the bottom of the fascia panel
towards the bracket and gently press
at the bottom of the panel until the
lip on the fascia engages and snaps
lock to the bracket.
Step 4. CHILD SAFETY
The American National Standard for Safety of Corded Window
Covering Products (ANSI) requires the use of a cord tie down (cord
tensioner) on all continuous loop cord systems. The use of such a
device is intended to significantly reduce the occurrence of infant or
small child strangulation injuries or deaths resulting from the looped
pull cords on various window treatment products.
The Cord Tensioner is installed on the Lift Cord before packaging.
The Tensioning device should be mounted in the proper position to
pull the cord taut in order to reduce the possibility of injury.
Follow the instructions included in the Tensioner Bracket Packet.
Step 5. HOLD DOWN INSTALLATION (optional)
Optional Hold Down Brackets
are mounted with the supplied
screws. With the shade at its
proper drop, place the pin of
each Hold Down into the hole in
each End Cap and mark the
screw holes. Make sure the
pins are level and aligned.
Raise the shade, then screw the
Hold Down Bracket into the
mounting surface.
Step 6. SKEW ADJUSTMENT (if necessary)
If the shade does not raise evenly, first make sure the mounting
brackets are mounted level with each other.
If the shade is level, pull the shade all of the
way down. Prepare a strip of masking tape
approximately 5" long. On the side of the
shade opposite of the skewing direction, and as
close to the end of the roller as possible, lift the
fabric toward the back of the shade using your
fingers and slide the tape with the sticky side
facing the roller up as far as possible. The tape
is to be running parallel to the roller.
Roll the shade up and check for skewing. If the shade is still skewing,
add another strip of tape on top of the first one. If the shade is now
skewing to the opposite direction, tear off about 1" of tape from the
last strip installed. The tape is to be torn from the end closest to the
center of the shade.
CLEANING AND CARE
Occasional light vacuuming with a soft bristle attachment or gentle
feather dusting is all that is required to keep Serenade Roller Shades
looking fresh and neat.
Most Serenade Shades may also be
ultrasonically cleaned, except those made with Phifer SheerWeave
fabrics.
Phifer SheerWeave fabrics are easy to maintain and only require
occasional vacuuming with a soft brush attachment or washing with
mild soap. Soak a sponge or damp cloth with the soapy solution and
gently wipe or blot the stain from the fabric. To dry, allow the shade
to air dry completely before raising.
If the shading has any wrinkling, lower the shade and leave in the
lowered position for 5 to 7 days. The heat from the sun will smooth
out any light wrinkles.
Installation Instructions
Roller Shades Roller Shades
152038 Rev. D 08/11/2009
Push the rail back until it is fully engaged.
Un-Install Headrail
To remove the shading, partially lower
the shading and insert a flat head
screwdriver as shown. Twist the
screwdriver until the headrail
disengages from the bracket.
Ultra Sleek Deluxe
Ultra Sleek Deluxe