Tow-starting and towing – BMW 2007 550I Sedan User Manual

Page 249

Advertising
background image

M

o

bi

lity

247

Re

fe

re

n

c

e

At

a

g

la

n

c

e

Co

n

tr

o

ls

D

riv

in

g ti

ps

C

o

m

m

uni

ca

ti

o

n

s

Na

v

iga

ti

on

En

te

rt

a

in

m

e

n

t

Starting engine

1.

Start the engine on the assisting vehicle
and allow it to run at idle for several minutes
at slightly increased speed.

2.

Start the engine on the other vehicle in the
usual way.
If the first starting attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.

3.

Let the engines run for a few minutes.

4.

Disconnect the jumper cables by reversing
the connection sequence.

Check the battery and recharge if necessary.

Never use spray fluids to start the
engine.

<

Tow-starting and towing

Observe applicable laws and regulations
for tow-starting and towing.

<

Do not transport any passengers other
than the driver in a vehicle that is being

towed.

<

Using tow fitting

The screw-on tow-fitting must always be car-
ried in the vehicle. It can be screwed in at the
front or rear of the BMW.
Sedan:
It is located in the toolkit in the luggage com-
partment lid, refer to page

234

.

Sports Wagon:
It is located in the toolkit behind the left side
panel in the cargo bay, refer to page

234

.

Use only the tow fitting provided with the
vehicle and screw it all the way in. Use the

tow fitting for towing only on roads. Avoid lateral
loading of the tow fitting, e.g. do not lift the vehi-
cle by the tow fitting. Otherwise damage to the
tow fitting and the vehicle can occur.

<

Access to screw thread

Press the arrow symbol on the cover in the
bumper.
Front:

Rear:

Being towed

Make sure that the ignition is switched on,
refer to page

60

, otherwise the low

beams, tail lamps, turn signals and windshield
wipers would not be available. Do not tow the
vehicle with the rear axle raised, as otherwise
the steering can turn to the left or right. When
the engine is stopped, there is no power assist.
This then requires increased effort for braking
and steering. Active steering is deactivated and
larger steering wheel movements are
required.

<

Switch on the hazard warning flashers depend-
ing on the local regulations. If the electrical sys-
tem fails, mark the vehicle to be towed, e.g. with
a sign or warning triangle in the rear window.

Online Edition for Part no. 01 41 0 013 308 02/07 BMW AG

Advertising