Braeburn 2220NC - Manual (Page 9)

8
6 Setting Your Program Schedule
Setting the Time and Day
1. In normal operating mode, press the DAY/TIME
button. The display will switch to the day/time
setting mode and the hour will be flashing.
2. Press or to adjust the hour.
Press
DAY/TIME.
3. Press or to adjust the minute. Press
DAY/TIME.
4. Press or to adjust the day of the week. Press RETURN to exit.
Extended Hold Period
(User Option 3)
The Extended Hold Period lets you select the period your thermostat will
hold the temperature when the HOLD mode is activated (See “Temperature
Adjustment”). When LNG is selected the thermostat will hold your
temperature indefinitely. When 24HR is selected, the thermostat will hold
your temperature for 24 hours and then return to the current program at
that time.
Service Filter Monitor
(User Option 4)
The Service Filter Monitor is a user selectable
service monitor that will display a reminder for
a required air filter replacement by flashing the
SERVICE FILTER segment in the display. When the
selected interval has been reached, and required
cleaning or replacement has been performed,
touch the
RETURN button to reset the timer and reset the service monitor.
Select OFF or a set number of days before the reminder will appear.
Adaptive Recovery Mode (early recovery)
(User Option 5)
During Adaptive Recovery Mode (ARM
™ ), room temperature is recovered
gradually by turning on the heating or cooling before the end of the set
back period. The set point temperature is changed to that of the upcoming
program temperature.
Tips Before Setting Your Program Schedule
• Make sure your current time and day of the week are set correctly.
• When programming, make sure the AM and PM indicators are correct.
This thermostat comes pre-programmed with a default energy saving
program. The following table outlines the pre-programmed times and
temperatures for heating and cooling in each of your 4 daily weekday and
weekend events. If you wish to use these settings then no further program-
ming is necessary: