Burris XTR II - Manual (Page 4)

Windage/Elevation Adjustment for Multi-Turn Knobs
– Applies to 2x-10; 3x-15x; 4x-10x; 5x-25x; and 8x-40x models –
The windage and elevation knobs are designed for
precise adjustment. The click value for each knob is
indicated on the dial.
For shooting at extreme distances, the elevation knob
offers up to 8 mils/rotation with multi revolutions of
adjustment (8x-40x models have 10 MOA/rotation).
This riflescope is shipped from the factory with the
optical center set 20 MOA below center. Without
tapered bases, the initial sight-in or bore sighting will
likely produce a considerably high initial point of
impact. Because of the Zero Stop feature, as shipped
from the factory the scope has no immediate capability
for downward point-of-impact adjustment.
Use the following procedure whenever you need
downward point of impact adjustment:
1) Turn the elevation adjust-
ment knob clockwise to “0”.
2) Use the 2mm hex wrench
supplied with the scope to
loosen the set screws on
the elevation adjustment
knob located just under
the top of the knob.
3) Pull up slightly on the
adjustment knob to the
second white hash mark on
the turret. Turn the knob
clockwise slightly more
(maybe 2-5 mils more) than
the number of mils needed
to achieve zero.
4) Retighten the set screws. Adjust the elevation down
the required amount.
5) Once the elevation adjustment is complete, once
again loosen the two set screws and reset the knob
3