Burris XTR II - Manual (Page 7)

Mounting the Scope
Most XTR II riflescopes require 34mm rings; the 1x-5x
requires 30mm rings. We recommend using high-quality
rings and bases, like the Burris Xtreme Tactical Rings
and Xtreme Tactical Bases. Quality components ensure
that your scope will remain safely and securely
mounted, and will provide the maximum accuracy. Use
care when mounting your scope as damage caused by
improper mounting is not covered by the Burris Forever
Warranty.
Care & Maintenance
The XTR II riflescope is fully waterproof and fogproof.
To protect the objective and ocular lenses, it comes
equipped with flip-up scope caps. In the event that
the lenses are subjected to dust, dirt, or mud, follow
these steps to clean and protect the lens surface. Fail-
ure to remove grit before final cleaning is sure to
damage lens coatings.
Coarse dirt/debris must be removed from the lens
surface. The most convenient way to clean a lens sur-
face is to use a Lens Pen. Position the scope so parti-
cles will fall away from the lens, and then use the Lens
Pen or soft brush to gently whisk away the debris while
blowing on the lens to dislodge the particles. For
heavy dirt, like dried mud, use a spray of clean water or
lens cleaning fluid to remove the dirt.
Your Burris riflescope will provide reliable performance
given reasonable care and treatment. All moving
assemblies are permanently lubricated. Only occasional
cleaning of the outside of the scope and the exterior
lenses is required. Never disassemble your scope.
Disassembly by anyone other than our factory will
void the warranty. If you have any other problems with
your riflescope, return it to the Burris factory for repair.
6