CompuSTAR CM1000A - Manual (Page 10)

18 17
No.2 Blue : Negative Starter Kill Output
250mA (-) negative output when armed. This wire will provide a (-)
negative output when system is locked and armed, and is pre-wired to the
starter kill relay.
(Note:This wire can also be used to trigger after-market L.E.D. kits and
other after-market accessories. Output must be diode isolated when used
to trigger after-market accessories.)
No.3 Red / Black : Negative Door Trigger
This wire monitors (-) negative trigger door-pins.
The proper wire will provide a (-) negative trigger only when the doors are
opened.
No.4 Red : Positive Door Trigger
This wire monitors (+) positive trigger door-pins.
The proper wire will provide a (+) positive trigger only when the doors are
opened.
No.5 Violet/Black : Negative Trunk Trigger
This input will monitor when the vehicles trunk is opened.
No.6 Light Blue/White : Positive Brake Trigger
Connect this wire at the brake switch.
The proper wire will test 12-volts (+) positive only when the foot brake
is pressed.
87
Relay
85
86 30
87a
Cut
Starter
Key Cylinder
Starter Wire
OFF
ACC
ON
START
.... Anti Jacking Mode ...
87
Relay
85
86 30
87a
Cut
Engine
Key Cylinder
Ignition Wire
OFF
ACC
ON
START
.... Starterkill Mode ...
+12V
CON3-3(-) Door Trigger
Dome Light
Door
Trigger SW
Door
Trigger SW
+12V
CON3-4(+) Door Trigger
Dome Light
CON 3-5
(-)Trunk Trigger Input
Trunk Lamp
+12V
+12V
CON3-6(+)Brake Trigger
Stop Lamp
Foot Brake S/W