CompuSTAR CM1000A - Manual (Page 6)

9 10
To use Anti-Jacking mode, the starter kill relay must be rewired to an
ignition kill, and Anti-Jacking mode must be turned on in the programming
options. With Anti-Jacking mode, if someone pulls you out of your vehicle
while it is running and attempts to drive off with it, you can then Panic the
system by holding the button down for at least 2.5 seconds. The system
will then sound the siren and flash the parking lights, 30 seconds later; the
system will activate the ignition kill which will disable the vehicle. This is so
you can activate Panic mode while the thief is still in range of your remote
and have enough time to get out of immediate danger before the vehicle is
disabled.
Anti-Jacking Mode
When operating in mute mode, the siren on the vehicle will not sound
during normal operations such as arm/disarm, lock/unlock, etc.
The siren will still sound if the alarm or Panic mode has been triggered. To
activate Mute mode, tap the and buttons simultaneously for a split
second. Do the same again to deactivate Mute mode.
Mute Mode - Silent Arm/Disarm
With this option turned on, if you leave your car without shutting all of the
doors, the parking lights will flash.
Door Open Indicator (Option 3)
In a manual transmission vehicle, if the ignition is powered up, the vehicle
can be compression or “bump” started without using the starter. Disabling the
ignition will keep the vehicle from starting.
Installation Guide Table of Contents
Installation Tips and Recommendations Page 11
CM1000A Wiring Diagram Page 13
CON 1 Page 14
CON 2 Page 15
CON 3 Page 16
CON 4 Page 19
CON 5 Page 19
Antenna Page 19
Option Menu Page 20
Programming Menu Options Page 21
Resetting Menu Options Page 22
Installation Guide