Carl Goldberg GPMA1926 Monster Pitts Electric ARF - Manual (Page 13)

13
5. Drill the outer hole on the control horn with a
1/16” drill and install one of the pushrod con
nectors.
6. Put the pushrod through the hole in the servo
connector, center both the rudder and servo,
and tightened the set screw on the pushrod
connector.
7. Repeat the procedure for the elevator
pushrod on the other side.
CABANE STRUTS
1. Collect the following items:
(2) front struts `( shorter ones)
(2) rear struts (longer ones)
(8) #2 x 3/8” screws
2. Identify the front and rear struts. The rear are
longer than the front. Identify the left and right
of both front and rear. When on the proper
side of the fuselage, the strut will lean to the
rear of the plane.
3. Screw the struts in place in the pre-made holes
on each side of the fuselage using the #2
screws.