Carl Goldberg GPMA1926 Monster Pitts Electric ARF - Manual (Page 5)

5
5. Mount the servo using the hardware that came
with the servo.
7. Install the control horns into the pre-drilled
holes in the ailerons. Install one horn on the
bottom of the lower wing aileron at the leading
edge.This horn will point forward like a normal
horn. This horn does not get a plate on top
9. Install another horn on the top wing aileron on
the bottom side at the trailing edge. This horn
will also point to the rear. Install a plate on the
top side. Glue all in place with Ultra Set thin
CA.
10. Locate the four servo connectors and the two
1/32” x 3” pushrods
8. Install another horn on the top of the lower wing
aileron at the trailing edge. This horn will point
to the rear. Install a plate on the top side.
6. Locate 6 of the control horns.
bottom of lower wing