Warnings about lithium polymer batteries – Carl Goldberg GPMA1926 Monster Pitts Electric ARF User Manual

Page 3

Advertising
background image

3

ITEMS NEEDED TO COMPLETE THIS AIRCRAFT

1 RADIO GUIDANCE SYSTEM (4 CHANNEL

MINIMUM REQUIRED WITH 4 SERVOS)

1 6” SERVO “Y” HARNESS

2 6” SERVO EXTENSION

1 ULTRA SET CA ACCELERATOR

1 ULTRA SET 1 OZ. BOTTLE CA MEDIUM

GLUE

1 ULTRA SET 1/2 OZ. BOTTLE CA THIN

GLUE

1 ULTRA SET 5 MINUTE EPOXY

1 1/4” FOAM RUBBER

1 MOTOR (AXI 2820 USE ON PROTOTYPE)

1 BATTERY (TW-3300XP-3S 3300 MAH LI-

POLY FROM HOBBY LOBBY USED IN

PROTOTYPE)

1 PROP (11 X 5.5 APC USED)

1 SPINNER (1-3/4” GOLDBERG USED)

1 SPEED CONTROL

TOOLS AND SUPPLIES FOR ASSEMBLY

.

MODELING OR UTILITY KNIFE

WORK SURFACE (24" X48")

SMALL STANDARD & PHILLIPS SCREW-
DRIVERS

MASKING TAPE

NEEDLE NOSE PLIERS

24” RULER

FLEXIBLE STRAIGHT-EDGE

30-60-90° x 6" TRIANGLE

SOFT PENCIL

A FEW STRAIGHT OR "T" PINS

WIRE CUTTER (DYKES)

OPTIONAL HEAT GUN/COVERING IRON

5 FT. LENGTH OF STRING

Warnings about Lithium

Polymer batteries

NEVER charge Lithium Polymer batteries with a

charger designed for NiCd, NiMH, or any

other type of battery chemistry. Use ONLY

the chargers listed under REQUIRES or

equivalent substitutes.

Do not allow Li-Po cells to overheat at any time. Cells

which reach greater than 140° Fahrenheit

(60C) will usually become damaged and

could catch fire.

Do not charge or discharge Li-Po cells on or near

combustible materials including paper, plastic,

carpets, vinyl, leather, wood, inside an R/C

model or full size automobile.

Do not expose Li-Po cells to water or moisture at any

time.

Do not store batteries near an open flame or heater.
Do not assemble Li-Po cells or pre-assembled packs

together with other Li-Po cells or packs.

Do not allow a Li-Po battery to be left unattended dur-

ing charging or discharging.

Always store Li-Po batteries in a secure location

away from children.

Always remove a Li-Po battery if model is involved in

any kind of

crash. Carefully inspect the

battery and connectors for even the

smallest damage.

CAUTION, cells may be hot!
Do not allow the electrolyte to get into eyes or on

skin. Wash affected areas immediately if

they come into contact with electrolyte.

Advertising