Casablanca Fan Company Stealth dc C45GxxxB - Manual (Page 15)

13
s
teaLth
®
dc
BULB INSTALLATION
Step 1. Screw the 100-watt Halogen bulb into
the socket. Figure 1. Do not touch the glass bulb
with your fingers–it is extremely important that
the glass be clean. If it is touched, or dirty, clean
carefully with a tissue. A dirty glass bulb will cause
the bulb to fail almost immediately.
INSTALLING THE GLASS
GLASS
Step 1. Position the indentations
in the outer rim of the glass so
that they line up with the tabs on
the inside surface of the fan light
fixture rim.
Step 2. Carefully lift the glass
shade up inside the light fixture as
far as it will go.
Step 3. Rotate the glass shade in
a clockwise direction until it falls
into the notch for each tab.
Step 4. Turn power back ON at
the circuit breaker or fusebox.
Step 5. This completes the
installation of the fan.
Step 1. Open battery
compartment door by pressing
down and sliding battery door
down.
Step 2. Install 1 "A23" "MN21"
alkaline battery in the space
provided. Please observe proper
polarity placement.
IMPORTANT! When installing the halogen bulb,
carefully cut off the end of the plastic sleeve the
bulb comes in and hold the bulb by the plastic
sleeve to screw it into the socket.
NOTE: In compliance with US Federal Energy
Regulations, this ceiling fan contains a device
that restricts the light kit to a maximum of 190
watts. Exceeding that limit or the marked limit
on this product may result in a fire hazard or
improper operation.
INDENTATION
FOR TAB
NOTCH
FOR TAB
HALOGEN BULB
100 WATT MAX.
+
-
CONTROL INSTALLATION AND OPERATION
CONTROL BATTERY INSTALLATION
FIGURE 1.