Whirlpool FEPZlOV - Manual (Page 6)

Solid elements hold heat longer than
conventional surface units. For best
cooking results, use a high setting for
only a short period of time. Then use a
lower setting to complete the cooking.
You may want to turn the solid element
surface unit OFF a few minutes before
you finish cooking.
^WARNING
Bum, Fire And
Property Damage Hazard
■ Be sure all control knobs are
turned to OFF and all signal
lights are off when you are not
cooking. Someone could he
burned or a fire could start if a
surface unit is accidentally left
on.
■ Solid elements stay hot for a long
time. Do not use the high setting
for long periods of time or leave
pans on hot elements when
cooking is done. Burned food and
damage to the cookware could
result.
Cookware
Pans should be the same size or larger
than the surface unit to prevent boil­
overs and hot handles.
Use only flat-bottomed utensils. Flat
bottoms allow maximum contact
between the pans and surface units for
fast, even cooking. Pans with uneven
bottoms or with raised patterns on the
bottoms are not suitable. Do not use
trivets, woks with skirts, or canners
with concave or ridged bottoms.
To check your cookware for flatness,
place a straight-edge across the bottom
of each piece. Rotate the straight-edge
across the bottom. If light shows
anywhere between the pan and the
straight-edge, the pan is not flat. Do not
use it.
Page 6
A warning
Bum And Product Damage Hazard
■ If the pan is too small for the
surface unit, you could be burned
by the heat from the exposed
section of the surface unit. Use
correctly sized cooking utensils to
prevent injury.
■ If a surface unit stays red for a long
time, the bottom of the pan is not
flat enough or is too small for the
surface unit. Prolonged usage of
incorrect utensils for long periods
of time can result in damage to the
surface unit, cooktop, wiring and
surrounding areas. To prevent
damage, use correct utensils, start
cooking on high setting and turn
control down to continue cooking.
Setting the clock and timer
(Models FEC350V, FEP350V,
FEP340V, FEP335V &
FEP330V)
Electronic clock and tinier
(Models FEP340V, FEP335V &
FEP330V)
The clock/timer acts as both a time-of-day
clock and as a minute timer.
To set time of day;
When the range is connected to power,
the clock display will blink at 88:88 until
the time-of-day is set. To set time-of-day,
depress the Set Button once. The triangle
and clock signal lights on the display will
light up and remain lit until the time is
set. Within 15 seconds, turn the Clock/
Timer Knob to the correct time.
To set the timer:
Turn the Clock/Timer Knob clockwise to
the desired setting, up to 9 hours 50
minutes. (Knob must be turned four or
five clicks before time will advance.) The
triangle and bell signal lights will light
up. The timer will count down the time
while flashing the time-of-day every 12
seconds. Three beeps will sound at the
end of the set time and the signal lights
will go off.
Electronic clock with cook and
minute timer (Models FEC350V &
FEP350V)
This electronic control acts as a time-of-
day clock, as a minute timer up to 9 hours
50 minutes, and as an automatic stop
timer which allows you to begin cooking
now and set the oven to turn itself off
later.
To set time of day:
When the range is connected to power,
the clock display will blink at 88:88 until
the time-of-day is set. Turn the Clock/
Timer Knob in either direction to set
time-of-day. (Knob must be turned four
or five clicks before time will advance.)
To set the minute timer:
Push the Set Button once. A beep will
sound and a bell will light on the display.
Turn the Clock/Timer Knob clockwise to
the desired setting, up to 9 hours 50
minutes.
NOTE: The knob must be turned within
15 seconds after the button is pushed.
The timer will count down the time and
sound a tone at the end of the set time.
To check time-of-day during a minute
timer interval:
■ Push the Set Button once. A beep
will sound and the time-of-day will
be displayed.
To return to the minute timer display:
■ Push the Set Button once. A beep
will sound and the minute timer will
reappear.
To set the automatic stop timer:
1. Set the Time Bake Switch to TIME
BAKE. The TIME BAKE Signal
Light will light.
2. Turn the Oven Temp Control to the
desired oven temperature.
3. Push the Set Button twice. A beep
will sound with each push and a
beU win light on the face of the
clock along with the word “AUTO"
4. Turn the Clock/Timer Knob to the
desired cook time up to 9 hours 50
minutes.
NOTE: Knob must be turned within 15
seconds after button is pushed.
The oven will turn on within the next
30-40 seconds and wUl turn off
automatically at the end of the set cook
time.
To check time-of-day during cooking;
■ Push the Set Button once. A beep
win sound and the time-of-day wni
be displayed.
To return to the cook time display:
■ Push the Set Button once. A beep
wni sound and the automatic cook
time will reappear.
At the end of the set cook time, a tone
win sound. Turn Oven Temp Control to
OFF and set the Time Bake Switch to
MANUAL BAKE.
IMPORTANT: After the oven has turned
off, the Time Bake Switch must be
returned to "Manual Bake". IF THE
TIME BAKE SWITCH IS NOT SET TO
“MANUAL BAKE", THE OVEN WILL
NOT WORK PROPERLY.