Whirlpool ED19CK - Manual (Page 4)

Install properly...
1. Allow
'/2
inch (1,25 cm] space on each side and at
the top of the refrigerator for ease of installation.
2. If the refrigerator is to be against a wall, you might
want to leave extra space so the door can be
opened wider
3. The refrigerator back can be flush against the wall.
Level refrigerator-freezer...
1
, Remove base grille (see page 7 ].
2. To raise front, turn each screw to the right,
3, To lower front, turn each screw to the left.
4. Check with level.
Remove sales labels...
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue;
1, Rub briskly with thumb to make a ball then remove,
OR
2, Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohoi or fiammabie or
toxic soivents, such as acetone, gasoline, car­
bon tetrachioride, etc. These can damage the
materiai.
NOTE; DO NOT REMOVE ANY PERMANENT IN­
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
3-prong grounding
type wall receptacle
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz,, AC only 15 or 20 ampere fused
and properly grounded eleotrical supply is re­
quired. It is recommended that a separate oirouit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacie which cannot be turned off with a switch
or puil chain. See individual electrical require­
ments and grounding instruotion sheet in your liter­
ature package.