Whirlpool FGS395Y - Manual (Page 33)

I F Y O U N E E D A S S I S T A N C E O R S E R V I C E
PROBLEM POSSIBLE CAUSE SOLUTION
Burner makes
popping noise
when on Burner is wet from washing. Let dry.
Control knob(s)
will not turn You are not pushing in before
turning. Push control knob(s) in before turning to a
setting.
Self-Cleaning
cycle will not
operate The range clock does not show
the correct time of day. Reset clock to show the correct time of
day. (See page 12.)
A delayed start time has been
programmed. Wait for the start time to be reached.
Cooking results
are not what you
expected The range is not level.
The oven temperature seems too
low or too high.
The oven was not preheated as
the recipe calls for.
The recipe has never been
tested or is not from a reliable
source.
The pans are not the type or size
recommended in the recipe.
There is not proper air circulation
around pan when baking.
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the oven door.
Level range. (See Installation Instruc­
tions.)
Adjust the oven temperature control. (See
“Adjusting the oven temperature control”
on page 15.)
Preheat oven if called for in recipe.
Use only tested recipes from a reliable
source.
Refer to a reliable cookbook for recom­
mended pan type and size.
Allow 1V2 to 2 inches (4-5 cm) on all sides
of the pans for air circulation. There must
be a minimum space of 1 inch (2.5 cm).
Adjust flame size to fit cooking utensil.
Completely close oven door.
The display is
flashing “88:88" There has been a power failure. Reset the clock. (See page 12.)
Display beeping
and flashing error
code
“F-1”-“F-10”
Push CANCEL. Call for service. (See
Step 3 on page 34.)
33