Whirlpool RAM4131A - Manual (Page 8)

O P E R A T I N G Y O U R W A S H E R
Using rinse and spin
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may want an extra rinse and spin.
1. Push Cycle Control Knob in and turn clock­
wise to one of the dots on the dial, as
illustrated.
2. Pull Cycle Control Knob out. The washer
will fill to selected load size, agitate, drain,
and spin.
What happens in each cycie
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (with
the selected water temperature) before agita­
tion and timing start. The washer will begin
agitating immediately after filling; agitation can
occur with the washer lid up or down. After
agitation starts, the knob turns clockwise until it
points to OFF and the cycle ends.
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: If your washer drains into a laundry tub,
remove lint collected in the tub or strainer.
Fill
№
Wash selected time
Orain-No agitation
Spin
K, ..
Fill
m
Rinse
Drain-No agitation
Spin
A
Off