Using rinse and spin, What happens in each cycle – Whirlpool 3366860 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R W A S H E R
Using rinse and spin
When using extra detergent for heavily
soiled clothes, or washing special-care
items, you may want an extra rinse and spin.
1. Push in the Cycle Control Knob and turn
clockwise to one of the dots, as illus
trated.
2. Pull out the Cycle Control Knob. The
washer fills to selected load size, agi
tates, drains, and spins.
2^
PERMANENT PRESS
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation can occur
with the washer lid up or down.
After agitation starts, the Cycle Control Knob
turns clockwise until it points to an OFF area
and the cycle ends.
The washer pauses briefly throughout
each cycle. These pauses are rx>rmal for
washer operation.
WASH
Rll
Wash selected time
Drain (or partial drain* *)
No agitation
*Tha Permanant Press cyda partially
drains, fills, agitatas briafly, and drains.
Spin
RINSE
Rll
Rir\se
_| Drain-No agKation
Spin-Spray rinse
Spin
Off