Whirlpool 8EDZOZK - Manual (Page 12)

Removing the freezer bin
For proper air nriovement, keep the freezer bin in
place when the refrigerator is operating.
To remove the bin:
1. Slide bin out to the stop.
2. Lift bin at the front to clear the stop.
3. Slide bin out the rest of the way.
To replace the bin:
1. Place bin on the slides.
2. Make sure the stops clear the front of the
slides.
3. Slide bin in.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using the automatic ice maker
(Factory-installed on ED22ZR, optional on ED20PK and ED20ZK)
If you have the automatic ice maker accessory
(Part No. ECKMF-90), or if you plan to add one
later, there are a few things you will want to
know:
• The ON/OFF lever is a wire signal arm.
Down ... to make ice automatically.
Up ... to shut off the ice maker.
NOTE: Do not turn ice maker on until it is
connected to the water supply. Instructions for -Supply.
ice maker water supply hook up are at­
tached to the back of the refrigerator
cabinet
' The dial or lever on the side of the ice maker
changes the size of the cubes.
* Shake the bin occasionally to keep cubes
separated and to obtain increased storage
capacrty.
It is normal for ice crescents to be attached by
a corner. They will break apart easily.
' You will hear water running when ice maker is
working. You’ll hear ice fall into the bin. Don’t
let these sounds bother you.
Raise
signal
arm to
stop ice
maker.
Lower
signal
arm to
start ice
maker.
11